adplus-dvertising

Welcome to the Peripherals and Interfacing with 8086 MCQs Page

Dive deep into the fascinating world of Peripherals and Interfacing with 8086 with our comprehensive set of Multiple-Choice Questions (MCQs). This page is dedicated to exploring the fundamental concepts and intricacies of Peripherals and Interfacing with 8086, a crucial aspect of Microprocessor. In this section, you will encounter a diverse range of MCQs that cover various aspects of Peripherals and Interfacing with 8086, from the basic principles to advanced topics. Each question is thoughtfully crafted to challenge your knowledge and deepen your understanding of this critical subcategory within Microprocessor.

frame-decoration

Check out the MCQs below to embark on an enriching journey through Peripherals and Interfacing with 8086. Test your knowledge, expand your horizons, and solidify your grasp on this vital area of Microprocessor.

Note: Each MCQ comes with multiple answer choices. Select the most appropriate option and test your understanding of Peripherals and Interfacing with 8086. You can click on an option to test your knowledge before viewing the solution for a MCQ. Happy learning!

Peripherals and Interfacing with 8086 MCQs | Page 7 of 11

Q61.
DAC (Digital to Analog Converter) finds application in
Discuss
Answer: (d).all of the mentioned
Q62.
To save the DAC from negative transients the device connected between OUT1 and OUT2 of AD 7523 is
Discuss
Answer: (b).Zener
Discuss
Answer: (d).all of the mentioned
Q64.
The DAC 0800 has a settling time of
Discuss
Answer: (a).100 milliseconds
Q65.
The device that is used to obtain an accurate position control of rotating shafts in terms of steps is
Discuss
Answer: (c).Stepper motor
Q66.
The internal schematic of a typical stepper motor has
Discuss
Answer: (d).4 windings
Q67.
The number of pulses required for one complete rotation of the shaft of the stepper motor is equal to the
Discuss
Answer: (a).number of internal teeth on a rotor
Q68.
A simple scheme for rotating the shaft of a stepper motor is called
Discuss
Answer: (c).wave scheme
Q69.
The firing angles of thyristors are controlled by
Discuss
Answer: (d).all of the mentioned
Discuss
Answer: (c).protecting low power circuit and isolation

Suggested Topics

Are you eager to expand your knowledge beyond Microprocessor? We've curated a selection of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!