Q. The internal schematic of a typical stepper motor has

View solution

Q. The number of pulses required for one complete rotation of the shaft of the stepper motor is equal to the

View solution

Q. A simple scheme for rotating the shaft of a stepper motor is called

View solution

Q. The firing angles of thyristors are controlled by

View solution

Q. The Isolation transformers are generally used for

View solution

Q. The number of counters that are present in the programmable timer device 8254 is

View solution

Q. The operation that can be performed on control word register is

View solution

Q. The mode that is used to interrupt the processor by setting a suitable terminal count is

View solution

Q. In mode 2, if N is loaded as the count value, then after (N-1) cycles, the output becomes low for

View solution

Q. The generation of a square wave is possible in the mode

View solution

Q. In control word register, if SC1=0 and SC0=1, then the counter selected is

View solution

Q. In control word format, if RL1=1, RL0=1 then the operation performed is

View solution

Q. If BCD=0, then the operation is

View solution

Q. The counter starts counting only if

View solution

Q. The control word register contents are used for

View solution

Q. The number of hardware interrupts that the processor 8085 consists of is

View solution

Q. The register that stores all the interrupt requests in it in order to serve them one by one on a priority basis is

View solution

Q. The register that stores the bits required to mask the interrupt inputs is

View solution

Q. The interrupt control logic

View solution

Q. In a cascaded mode, the number of vectored interrupts provided by 8259A is

View solution