Q. The number of 8-bit registers that a register bank contain is

View solution

Q. If RS1=1, RS0=0, then the register bank selected is

View solution

Q. If RS1=1, RS0=1, then the register bank selected is

View solution

Q. The PCON register consists of

View solution

Q. The on-chip oscillator is stopped in

View solution

Q. In idle mode, the device that is disabled is

View solution

Q. The only way to terminate the power down mode is to

View solution

Q. The idle mode can be terminated by

View solution

Q. Which of the following is an external interrupt?

View solution

Q. The interrupts, INT0(active low) and INT1(active low) are processed internally by flags

View solution

Q. The flags IE0 and IE1, are automatically cleared after the control is transferred to respective vector if the interrupt is

View solution

Q. If the external interrupt sources control the flags IE0 and IE1, then the interrupt programmed is

View solution

Q. The pulses at T0 or T1 pin are counted in

View solution

Q. In timer mode, the oscillator clock is divided by a prescalar

View solution

Q. The serial port interrupt is generated if

View solution

Q. In serial port interrupt, after the control is transferred to the interrupt service routine, the flag that is cleared is

View solution

Q. The atleast number of machine cycles for which the external interrupts that are programmed level-sensitive should remain high is

View solution

Q. If the external interrupts are programmed edge sensitive, then they should remain high for atleast

View solution

Q. The timer generates an interrupt, if the count value reaches to

View solution

Q. The external interrupt that has the lowest priority among the following is

View solution