Q. Which of the following electronic component is not found in IC’s ?

View solution

Q. A given memory chip has 14 address pins and 8 data pins. It has the following number of locations.

View solution

Q. The instruction: MOV CL, [BX] [DI] + 8 represents the ............... addressing mode.

View solution

Q. The power dissipation of a flip-flop is 3 mW. The power dissipation of a digital system with 4 flip-flops is given by

View solution

Q. A binary ripple counter is required to count up to 16383. How many flip-flops are required ?

View solution

Q. Which one of the following is not an addressing mode?

View solution

Q. Computers can have instruction formats with

View solution

Q. Which is not a typical program control instruction?

View solution

Q. Interrupt which arises from illegal or erroneous use of an instruction or data is

View solution

Q. Match the following:

a. TTL                 i. High component density
b. ECL               ii. Low power consumption
c. MOS               iii. Evolution of “diodetransistor- logic”
d. CMOS           iv. High speed digital circuits

Codes:
      a   b   c    d

View solution

Q. The branch logic that provides making capabilities in the control unit is known as

View solution

Q. Cached and interleaved memories are ways of speeding up memory access between CPU’s and slower RAM. Which memory models are best suited (i.e. improves the performance most) for which programs ?

(i) Cached memory is best suited for small loops.
(ii) Interleaved memory is best suited for small loops
(iii) Interleaved memory is best suited for large sequential code.
(iv) Cached memory is best suited for large sequential code.

View solution

Q. Which of the following logic families is well suited for high-speed operations ?

View solution

Q. A complete microcomputer system consists of

View solution

Q. Where does a computer add and compare data ?

View solution

Q. Pipelining strategy is called implement

View solution

Q. The concept of pipelining is most effective in improving performance if the tasks being performed in different stages :

View solution

Q. Identify the addressing modes of below instructions and match them :

(a) ADI (1) Immediate addressing
(b) STA (2) Direct addressing
(c) CMA (3) Implied addressing
(d) SUB (4) Register addressing

View solution

Q. Identify the devices given below with their IC numbers :

(i) USART                                 (a) 8251
(ii) Micro controller                (b) 8051
(iii) Interrupt controller         (c) 8259
(iv) DMA controller                 (d) 8257

      (i)   (ii)    (iii) (iv)

View solution

Q. On receiving an interrupt from an I/O device, the CPU

View solution