Q. The data interface and control unit consists of

View solution

Q. The word that optimizes the NDP performance, by maintaining a record of empty and non-empty register locations is

View solution

Q. The part of the data interface and control unit, that points to the source of exception generated is

View solution

Q. The data bus in a floating point unit is of

View solution

Q. The arrangement of data that is to be shifted successively, whenever required for the execution, is done by

View solution

Q. The word that is used to select one of the processing options, among the provided ones is

View solution

Q. After reset of 80287, the control bit that is initialized to zero is

View solution

Q. The bits that are modified depending upon the result of the execution of arithmetic instructions are

View solution

Q. If the stack flag is set, and condition code bit C1=1, then the stack is

View solution

Q. If the stack flag is set, and condition code bit C1=0, then the stack is

View solution

Q. The bits that affect the result of arithmetic operations like ADD, SUB, MUL, DIV are

View solution

Q. The precision is decided by the

View solution

Q. If Numeric Processor Write (NPWR) active-low input pin is activated, then it enables a data transfer from

View solution

Q. If Numeric Processor Read (NPRD) active-low input pin is activated, then it enables a data transfer from

View solution

Q. Which of the input line(s) indicate that the CPU is performing an escape operation, and enables 80287 to execute the next instruction?

View solution

Q. For which pin of 80286 is the active low pin, BUSY of 80287, connected?

View solution

Q. If Clock Mode (CM) input pin is held low, then the CLK input is divided by

View solution

Q. Which of the following pin is not involved in the interface of 80287 with 80286?

View solution

Q. The PEACK (active low) when activated, the pin that goes into deactivation is

View solution