Q. The bits that affect the result of arithmetic operations like ADD, SUB, MUL, DIV are

View solution

Q. If the stack flag is set, and condition code bit C1=0, then the stack is

View solution

Q. If the stack flag is set, and condition code bit C1=1, then the stack is

View solution

Q. The bits that are modified depending upon the result of the execution of arithmetic instructions are

View solution

Q. After reset of 80287, the control bit that is initialized to zero is

View solution

Q. The word that is used to select one of the processing options, among the provided ones is

View solution

Q. The arrangement of data that is to be shifted successively, whenever required for the execution, is done by

View solution

Q. The data bus in a floating point unit is of

View solution

Q. The part of the data interface and control unit, that points to the source of exception generated is

View solution

Q. The word that optimizes the NDP performance, by maintaining a record of empty and non-empty register locations is

View solution

Q. The data interface and control unit consists of

View solution

Q. The unit that provides and controls the interface, between the internal 80287 bus and 80286 bus via data buffer is

View solution

Q. Which of the following is not a block of an architecture of 80287?

View solution

Q. In LGDT instruction, while loading 6 bytes, the first word is loaded into the field of

View solution

Q. The instruction that loads 6 bytes from a memory block, pointed to by the effective address of the operand, into global descriptor table register is

View solution

Q. The instruction that determines whether the segment pointed to, by a 16-bit register, can be accessed from the current privilege level is

View solution

Q. The CLTS (Clear Task Switch Flag) instruction records every execution of WAIT and ESC and is trapped if the flag(s)

View solution

Q. The instruction that is used to check whether a signed array offset is within the limit, defined for it by the starting and ending index is

View solution

Q. The instruction that determines the number of bytes, to be copied into the new stack frame, from the previous stack is

View solution

Q. The instruction that is used to exit the procedure is

View solution