Question
a.
restricted use of segments
b.
restricted accesses to segments
c.
privileged instructions or operations
d.
none of the mentioned
Posted under Microprocessor
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. The mechanism that is executed at certain privilege levels, determined by CPL (Current Privilege Level) and I/O privilege level (IOPL) is
Similar Questions
Discover Related MCQs
Q. If CPL is not of the required privilege level, then the instructions that get affected is
View solution
Q. If CPL is greater than zero, then the instruction that remains unaffected is
View solution
Q. The condition, “CPL not equals to zero” satisfies when executing the instruction
View solution
Q. While executing the instruction IN/OUT, the condition of CPL is
View solution
Q. The instruction at which the exception is generated, but the processor extension registers contain the address of failing instruction is
View solution
Q. The exception that has no error code on a stack is
View solution
Q. Which of the following is protected mode exception?
View solution
Q. Which of the following operation is not carried out by 80286?
View solution
Q. After completion of the first cycle, the first task is again scheduled for the next cycle. This process is known as
View solution
Q. The operation that is provided by the internal architecture, to save the execution state of a task is
View solution
Q. The instruction that can be used to carry out task switch operation is
View solution
Q. The IRET instruction gets back the execution state of the previous task, if
View solution
Q. The NT flag is set by the task switch operation, that is initiated by
View solution
Q. The 80286 executes LMSW instruction to enter into
View solution
Q. The instruction that sets the zero flag, if the segment referred to, by the selector can be read is
View solution
Q. The instruction that sets the zero flag, if the segment referred to by the selector, can be written as
View solution
Q. The instruction that reads the descriptor access rights byte into the register is
View solution
Q. The instruction that reads the segment limit into the register, if privilege rules and descriptor type allow is
View solution
Q. The instruction that adjusts the RPL (Requested Privilege Level) of the selector, to the numeric maximum of current selector RPL value is
View solution
Q. Which of the following is a supporting chip of 80286?
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Microprocessor? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
