Q. The data segment access refers to

View solution

Q. An exception is generated when

View solution

Q. The mechanism to provide protection, that is accomplished with the help of read/write privileges is

View solution

Q. The Local descriptor table (LDT) and Global descriptor table (GDT) are present in

View solution

Q. The mechanism that is accomplished using descriptor usages limitations and rules of privilege check is

View solution

Q. The mechanism that is executed at certain privilege levels, determined by CPL (Current Privilege Level) and I/O privilege level (IOPL) is

View solution

Q. If CPL is not of the required privilege level, then the instructions that get affected is

View solution

Q. If CPL is greater than zero, then the instruction that remains unaffected is

View solution

Q. The condition, “CPL not equals to zero” satisfies when executing the instruction

View solution

Q. While executing the instruction IN/OUT, the condition of CPL is

View solution

Q. The instruction at which the exception is generated, but the processor extension registers contain the address of failing instruction is

View solution

Q. The exception that has no error code on a stack is

View solution

Q. Which of the following is protected mode exception?

View solution

Q. Which of the following operation is not carried out by 80286?

View solution

Q. After completion of the first cycle, the first task is again scheduled for the next cycle. This process is known as

View solution

Q. The operation that is provided by the internal architecture, to save the execution state of a task is

View solution

Q. The instruction that can be used to carry out task switch operation is

View solution

Q. The IRET instruction gets back the execution state of the previous task, if

View solution

Q. The NT flag is set by the task switch operation, that is initiated by

View solution

Q. The 80286 executes LMSW instruction to enter into

View solution