Q. The task privilege level at the instant of execution is called

View solution

Q. Once the CPL is selected, it can be changed by

View solution

Q. The data segments defined in GDT (global descriptor table) and the LDT (local descriptor table) can be accessed by a task with

View solution

Q. A task with privilege level 0, doesn’t refer to all the lower level privilege descriptors in

View solution

Q. The selector RPL that uses a less trusted privilege than the current privilege level for further use is known as

View solution

Q. The effective privilege level is

View solution

Q. The task requesting an access to a descriptor is allowed to access after checking the

View solution

Q. A CALL instruction can reference only a code segment descriptor with

View solution

Q. The RPL of a selector that referred to the code descriptor must have

View solution

Q. The instruction that refers to only code segment descriptors with DPL equal to or less than the task CPL is

View solution

Q. When a JUMP instruction references a Task State Segment(TSS) descriptor, then DPL must be

View solution

Q. The data segment access refers to

View solution

Q. An exception is generated when

View solution

Q. The mechanism to provide protection, that is accomplished with the help of read/write privileges is

View solution

Q. The Local descriptor table (LDT) and Global descriptor table (GDT) are present in

View solution

Q. The mechanism that is accomplished using descriptor usages limitations and rules of privilege check is

View solution

Q. The mechanism that is executed at certain privilege levels, determined by CPL (Current Privilege Level) and I/O privilege level (IOPL) is

View solution

Q. If CPL is not of the required privilege level, then the instructions that get affected is

View solution

Q. If CPL is greater than zero, then the instruction that remains unaffected is

View solution

Q. The condition, “CPL not equals to zero” satisfies when executing the instruction

View solution