Q. HLT opcode means

View solution

Q. What is SIM?

View solution

Q. The ROM programmed during manufacturing process itself is called

View solution

Q. A field programmable ROM is called

View solution

Q. The operations executed by two or more control units are referred as

View solution

Q. Program counter in a digital computer

View solution

Q. At the beginning of a fetch cycle, the contents of the program counter are

View solution

Q. Which components are NOT found on chip in a microprocessor but may be found on chip in a micro-controller?

View solution

Q. For the purpose of data processing an efficient assembly language programmer makes use of the general purpose registers rather than memory. The reason is

View solution

Q. The first machine cycle of an instruction is always

View solution

Q. The output data lines of microprocessor and memories are usually tristated because

View solution

Q. The correct sequence of steps in the instruction cycle of a basic computer is

View solution

Q. The register which holds the information about the nature of results of arithmetic and logic operations is called as

View solution

Q. Consider the following statements:
Arithmetic Logic Unit (ALU)
1.Performs arithmetic operations
2.Performs comparisons.
3.Communicates with I/O devices
4.Keeps watch on the system
Which of these statements are correct?

View solution

Q. Ready pin of microprocessor is used

View solution

Q. Both the ALU and control section of CPU employ which special purpose storage location?

View solution

Q. A high on RESET OUT signifies that

View solution

Q. In a vector interrupt

View solution

Q. The content of the A15-A8 (higher order address lines) while executing “IN 8-bit port address” instruction are

View solution

Q. Which one of the following interrupt is only level triggering?

View solution