Question
a.
Micro-operations
b.
Macro-operations
c.
Multi-operations
d.
Bi control-operations
Posted under Microprocessor
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. The operations executed by two or more control units are referred as
Similar Questions
Discover Related MCQs
Q. Program counter in a digital computer
View solution
Q. At the beginning of a fetch cycle, the contents of the program counter are
View solution
Q. Which components are NOT found on chip in a microprocessor but may be found on chip in a micro-controller?
View solution
Q. For the purpose of data processing an efficient assembly language programmer makes use of the general purpose registers rather than memory. The reason is
View solution
Q. The first machine cycle of an instruction is always
View solution
Q. The output data lines of microprocessor and memories are usually tristated because
View solution
Q. The correct sequence of steps in the instruction cycle of a basic computer is
View solution
Q. The register which holds the information about the nature of results of arithmetic and logic operations is called as
View solution
Q. Consider the following statements:
Arithmetic Logic Unit (ALU)
1.Performs arithmetic operations
2.Performs comparisons.
3.Communicates with I/O devices
4.Keeps watch on the system
Which of these statements are correct?
View solution
Q. Ready pin of microprocessor is used
View solution
Q. Both the ALU and control section of CPU employ which special purpose storage location?
View solution
Q. A high on RESET OUT signifies that
View solution
Q. In a vector interrupt
View solution
Q. The content of the A15-A8 (higher order address lines) while executing “IN 8-bit port address” instruction are
View solution
Q. Which one of the following interrupt is only level triggering?
View solution
Q. Which one of the following instruction may be used to clear the accumulator content irrespective of its initial value?
View solution
Q. ___________ signal prevent the microprocessor from reading the same data more than one.
View solution
Q. Data transfer between the microprocessor for peripheral takes place through __________.
View solution
Q. 8255A operates with ________ power supply.
View solution
Q. The _______ allow data transfer between memory and peripherals.
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Microprocessor? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
