adplus-dvertising
frame-decoration

Question

Program counter in a digital computer

a.

Counts the numbers of programs run in the machine.

b.

Counts the number of times a subroutine is called.

c.

Counts the number of times the loops are executed.

d.

Points the memory address of the next instruction to be fetched.

Posted under Microprocessor

Answer: (d).Points the memory address of the next instruction to be fetched.

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. Program counter in a digital computer

Similar Questions

Discover Related MCQs

Q. At the beginning of a fetch cycle, the contents of the program counter are

Q. Which components are NOT found on chip in a microprocessor but may be found on chip in a micro-controller?

Q. For the purpose of data processing an efficient assembly language programmer makes use of the general purpose registers rather than memory. The reason is

Q. The first machine cycle of an instruction is always

Q. The output data lines of microprocessor and memories are usually tristated because

Q. The correct sequence of steps in the instruction cycle of a basic computer is

Q. The register which holds the information about the nature of results of arithmetic and logic operations is called as

Q. Consider the following statements:
Arithmetic Logic Unit (ALU)
1.Performs arithmetic operations
2.Performs comparisons.
3.Communicates with I/O devices
4.Keeps watch on the system
Which of these statements are correct?

Q. Ready pin of microprocessor is used

Q. Both the ALU and control section of CPU employ which special purpose storage location?

Q. A high on RESET OUT signifies that

Q. In a vector interrupt

Q. The content of the A15-A8 (higher order address lines) while executing “IN 8-bit port address” instruction are

Q. Which one of the following interrupt is only level triggering?

Q. Which one of the following instruction may be used to clear the accumulator content irrespective of its initial value?

Q. ___________ signal prevent the microprocessor from reading the same data more than one.

Q. Data transfer between the microprocessor for peripheral takes place through __________.

Q. 8255A operates with ________ power supply.

Q. The _______ allow data transfer between memory and peripherals.

Q. Expansion of SPGA is _________.