Q. The correct sequence of steps in the instruction cycle of a basic computer is

View solution

Q. The register which holds the information about the nature of results of arithmetic and logic operations is called as

View solution

Q. Consider the following statements:
Arithmetic Logic Unit (ALU)
1.Performs arithmetic operations
2.Performs comparisons.
3.Communicates with I/O devices
4.Keeps watch on the system
Which of these statements are correct?

View solution

Q. Ready pin of microprocessor is used

View solution

Q. Both the ALU and control section of CPU employ which special purpose storage location?

View solution

Q. A high on RESET OUT signifies that

View solution

Q. In a vector interrupt

View solution

Q. The content of the A15-A8 (higher order address lines) while executing “IN 8-bit port address” instruction are

View solution

Q. Which one of the following interrupt is only level triggering?

View solution

Q. Which one of the following instruction may be used to clear the accumulator content irrespective of its initial value?

View solution

Q. ___________ signal prevent the microprocessor from reading the same data more than one.

View solution

Q. Data transfer between the microprocessor for peripheral takes place through __________.

View solution

Q. 8255A operates with ________ power supply.

View solution

Q. The _______ allow data transfer between memory and peripherals.

View solution

Q. Expansion of SPGA is _________.

View solution

Q. Pentium-pro processor design implements________ micro architecture.

View solution

Q. The number of hardware chips needed for multiple digit display can be minimized by using the technique called ______.

View solution

Q. An RS-232 interface is ____________.

View solution

Q. Expansion for DTE is ______.

View solution

Q. Compared with RS-232, USB is faster and uses___________.

View solution