adplus-dvertising
frame-decoration

Question

High speed USB devices neglect

a.

Handshake packet

b.

Token packet

c.

PRE packet

d.

Data packet

Posted under Microprocessor

Answer: (c).PRE packet

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. High speed USB devices neglect

Similar Questions

Discover Related MCQs

Q. The bit packet that commands the device either to receive data or transmit data in transmission of USB asynchronous communication is

Q. The USB supports the signaling rate of

Q. The disadvantage of RS-232C is

Q. The signal that may be used either to interrupt the CPU or polled by the CPU is

Q. TXD(Transmitted Data Output) pin carries serial stream of the transmitted data bits along with

Q. In 8251A, the pin that controls the rate at which the character is to be transmitted is

Q. If the data transmission takes place in either direction, but at a time data may be transmitted only in one direction then, it is of

Q. If the data is transmitted only in one direction over a single communication channel, then it is of

Q. Which of the following is not a mode of data transmission?

Q. If any change in sensor value is detected at the end of a sensor matrix scan, then the IRQ line

Q. The flag that increments automatically after each read or write operation to the display RAM is

Q. The FIFO status word is used to indicate the error in

Q. The data that is entered from the left side of the display unit is of

Q. When a key is pressed, the debounce circuit waits for 2 keyboard scans and then checks whether the key is still depressed in

Q. The mode that is programmed using “end interrupt/error mode set command” is

Q. When a key is pressed, a debounce logic comes into operation in

Q. The registers that hold the address of the word currently being written by the CPU from the display RAM are

Q. The sensor RAM acts as 8-byte first-in-first-out RAM in

Q. The registers that store the keyboard and display modes and operations programmed by CPU are

Q. In the application where all the interrupting devices are of equal priority, the mode used is