Question
a.
IF
b.
RF
c.
AI
d.
WF
Posted under Peripherals and Interfacing with 8086 Microprocessor
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. The flag that increments automatically after each read or write operation to the display RAM is
Similar Questions
Discover Related MCQs
Q. If any change in sensor value is detected at the end of a sensor matrix scan, then the IRQ line
View solution
Q. Which of the following is not a mode of data transmission?
View solution
Q. If the data is transmitted only in one direction over a single communication channel, then it is of
View solution
Q. If the data transmission takes place in either direction, but at a time data may be transmitted only in one direction then, it is of
View solution
Q. In 8251A, the pin that controls the rate at which the character is to be transmitted is
View solution
Q. TXD(Transmitted Data Output) pin carries serial stream of the transmitted data bits along with
View solution
Q. The signal that may be used either to interrupt the CPU or polled by the CPU is
View solution
Q. The disadvantage of RS-232C is
View solution
Q. The USB supports the signaling rate of
View solution
Q. The bit packet that commands the device either to receive data or transmit data in transmission of USB asynchronous communication is
View solution
Q. High speed USB devices neglect
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Microprocessor? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
.png)