Q. At the end of ISR, the instruction should be

View solution

Q. When the CPU executes IRET,

View solution

Q. The interrupt for which the processor has the highest priority among all the external interrupts is

View solution

Q. The interrupt for which the processor has highest priority among all the internal interrupts is

View solution

Q. In case of string instructions, the NMI interrupt will be served only after

View solution

Q. The NMI pin should remain high for atleast

View solution

Q. The INTR signal can be masked by resetting the

View solution

Q. For the INTR signal, to be responded to in the next instruction cycle, it must go ________ in the last clock cycle of the current instruction.

View solution

Q. The status of the pending interrupts is checked at

View solution

Q. Once the processor responds to an INTR signal, the IF is automatically

View solution

Q. If the pin LOCK (active low based) is low at the trailing edge of the first ALE pulse, then till the start of the next machine cycle, the pin LOCK (active low) is

View solution

Q. With the trailing edge of the LOCK (active low), the INTA (active low) goes low and remains in it for

View solution

Q. The method of defining the interrupt service routine for software is

View solution

Q. While programming for any type of interrupt, the interrupt vector table is set

View solution

Q. To execute a program one should

View solution

Q. Procedures are also known as

View solution

Q. Procedures, for their execution, require

View solution

Q. The technique that is used to pass the data or parameter to procedures in assembly language program is by using

View solution

Q. If a procedure is interactive, then

View solution

Q. For passing the parameters to procedures using the PUBLIC and EXTRN directives, it must be declared PUBLIC in the

View solution