Q. The NMI pin should remain high for atleast

View solution

Q. The INTR signal can be masked by resetting the

View solution

Q. For the INTR signal, to be responded to in the next instruction cycle, it must go ________ in the last clock cycle of the current instruction.

View solution

Q. The status of the pending interrupts is checked at

View solution

Q. Once the processor responds to an INTR signal, the IF is automatically

View solution

Q. If the pin LOCK (active low based) is low at the trailing edge of the first ALE pulse, then till the start of the next machine cycle, the pin LOCK (active low) is

View solution

Q. With the trailing edge of the LOCK (active low), the INTA (active low) goes low and remains in it for

View solution

Q. The method of defining the interrupt service routine for software is

View solution

Q. While programming for any type of interrupt, the interrupt vector table is set

View solution

Q. To execute a program one should

View solution

Q. Procedures are also known as

View solution

Q. Procedures, for their execution, require

View solution

Q. The technique that is used to pass the data or parameter to procedures in assembly language program is by using

View solution

Q. If a procedure is interactive, then

View solution

Q. For passing the parameters to procedures using the PUBLIC and EXTRN directives, it must be declared PUBLIC in the

View solution

Q. The technique to estimate the size of an executable program, before it is assembled and linked is

View solution

Q. To estimate the size of an executable program before it is assembled and linked, the programming methodology concerned is by writing

View solution

Q. If a number of instructions are repeating through the main program, then to reduce the length of the program, __________ is used.

View solution

Q. A macro can be defined as

View solution

Q. A macro can be used as ________

View solution