Q. What is the size of a sector?

View solution

Q. In which phase of the laser printing process is a positive charge placed on the paper to pull the toner from the print drum?

View solution

Q. You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?

View solution

Q. To prevent toner from sticking to a laser printer's heat rollers, apply which of the following:

View solution

Q. What would you ask to determine if the display is working?

View solution

Q. Your modem does not respond when you try to dial out. You try another modem on another computer and get the same result. What is the most likely problem?

View solution

Q. With a dot matrix printer, light then dark print is most commonly caused by:

View solution

Q. RTS stands for

View solution

Q. What can you use to ensure power is not interrupted, resulting in corrupted data?

View solution

Q.
What command is used to hang up a MODEM when using the "AT Command set"?

View solution

Q. The standard IRQ for the floppy drive is?

View solution

Q. A keyboard locks up intermittently even when replaced with a new keyboard. What is the LEAST likely cause of the problem?

View solution

Q. During the laser printer's conditioning phase a uniform charge of _____ is placed on the photosensitive drum.

View solution

Q. You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem?

View solution

Q. After you service a laser printer, you notice dirty print. Which of the following would correct the problem.

View solution

Q. What command is used to reset a MODEM ?

View solution

Q. Modems use _____ transmission.

View solution

Q. What command is used to hand up a MODEM when using the "AT Answer Command set"?

View solution

Q. When you boot a PC and don't hear any beep, this could suggest which of the following?

View solution

Q. After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:

View solution