Question
a.
ready to start
b.
ready to switch
c.
request to send
d.
request to scan
Posted under Computer Hardware
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. RTS stands for
Similar Questions
Discover Related MCQs
Q. What can you use to ensure power is not interrupted, resulting in corrupted data?
View solution
Q.
What command is used to hang up a MODEM when using the "AT Command set"?
View solution
Q. The standard IRQ for the floppy drive is?
View solution
Q. A keyboard locks up intermittently even when replaced with a new keyboard. What is the LEAST likely cause of the problem?
View solution
Q. During the laser printer's conditioning phase a uniform charge of _____ is placed on the photosensitive drum.
View solution
Q. You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem?
View solution
Q. After you service a laser printer, you notice dirty print. Which of the following would correct the problem.
View solution
Q. What command is used to reset a MODEM ?
View solution
Q. Modems use _____ transmission.
View solution
Q. What command is used to hand up a MODEM when using the "AT Answer Command set"?
View solution
Q. When you boot a PC and don't hear any beep, this could suggest which of the following?
View solution
Q. After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the:
View solution
Q. A customer has just installed a new cd-rw. the system was working fine before the installation, but now the cdrom does not work, what should you suggest that the customer do?
View solution
Q. Which is the most difficult environmentally to dispose of?
View solution
Q. What is the most likely cause of an "FDD controller Failure" error message?
View solution
Q. What is the jumper setting on a SCSI device to configure it to use the fourth SCSI id? Remember, SCSI ids start with zero.
View solution
Q. ISDN stands for:
View solution
Q. ISDN uses _____ technology.
View solution
Q. A laser printer generates a totally black page, what is the cause?
View solution
Q. You must service the laser printer in your office. Which part of the printer should you avoid touching because it is hot?
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Computer Hardware? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!