Q. The process of fetching the instructions in advance, and storing in the queue is called

View solution

Q. The CPU must flush out the prefetched instructions immediately following the branch instruction in

View solution

Q. The device that interface and control the internal data bus with the system bus is

View solution

Q. The register bank of Execution Unit of 80286 is used as

View solution

Q. Which of the following is not an interrupt generated by 80286?

View solution

Q. For which of the following instruction does the return address point to instruction causing exception?

View solution

Q. The instruction that comes into action, if the trap flag is set is

View solution

Q. The interrupt that has the highest priority among the following is

View solution

Q. The interrupt that has the lowest priority among the following is

View solution

Q. The 80386 Microprocessor family is a _____ bit microprocessor.

View solution

Q. In which year, 80386 microprocessor was introduced?

View solution

Q. Which device is high-performance member of the 80386 family of MPUs?

View solution

Q. The 80486 family was introduced in the year ______.

View solution

Q. ________ maintains real modes protected-mode software compatibility with 80386 architecture.

View solution

Q. 80486DX was followed by ________.

View solution

Q. In 8279 Strobed input mode, the control line goes low. The data on return lines is strobed in the
___________.

View solution

Q. ________ bit in ICW1 indicates whether the 8259A is cascade mode or not ?

View solution

Q. In 8279, a scanned sensor matrix mode, if a sensor changes its state, the __________ line goes ___________ to interrupt the CPU.

View solution

Q. In 80186, the timer which connects to the system clock is

View solution

Q. Which pins are general purpose I/O pins during mode-2 operation of the 82C55?

View solution