Q. Each of the clock cycles from the previous section of execution, becomes a

View solution

Q. When an instruction is stalled, all instructions issued later than the stalled instructio and hence not as far along in the pipeline, are also

View solution

Q. The set of instructions examined as candidates for potential execution is called the

View solution

Q. The effectiveness of any branch prediction scheme depends both on the accuracy of the scheme and the frequency of conditional branches, which vary in SPEC from

View solution

Q. During the execution of DADD R1,R2,R3; DSUB R4,R1,R5; AND R6,R1,R7; OR R8,R1,R9; XOR R10,R1,R11, DSUB instruction reads the value during its ID stage. This problem is called a

View solution

Q. Exceptions that occur within instructions are usually

View solution

Q. When the compiler attempts to schedule instructions to avoid the hazard; this approach is called

View solution

Q. Decoding is done in parallel with reading registers, which is possiblebecause the register specifiers are at a fixed location, the stated technique is called a

View solution

Q. Pipelining increases the CPU instruction

View solution

Q. Control hazards can cause a greater performance loss for MIPS pipeline than do

View solution

Q. The sum of the contents of the base register and the sign-extended offset is used as a memory address, the sum is known as

View solution

Q. The presence of antidependences and output dependences, leads to

View solution

Q. The process of letting an instruction move from the instruction decode stage into the execution stage of this pipeline is usually called

View solution

Q. To solve the problems with a simple hardware technique called forwarding, also known as

View solution

Q. Every MIPS instruction can be implemented in at most

View solution

Q. Code containing redundant loads, stores, and other operations that might be eliminated by an optimizer, is a

View solution

Q. Delays arising from the use of a load result 1 or 2 cycles after the loads, refers as

View solution

Q. Situations that prevent the next instruction in the instruction stream, from executing during its designated clock cycle are known as

View solution

Q. The simplest dynamic branch-prediction scheme is a

View solution

Q. When an instruction is guaranteed to complete, it is called

View solution