adplus-dvertising
frame-decoration

Question

A queue holding data while the data are waiting to be written in memory, is known as

a.

Read buffer

b.

Queue buffer

c.

Write buffer

d.

Data buffer

Answer: (c).Write buffer

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. A queue holding data while the data are waiting to be written in memory, is known as

Similar Questions

Discover Related MCQs

Q. Cache having 64 blocks and a block-size of 16 bytes, will have block-no for address 1200 map to

Q. The spatial locality, is also known as

Q. In terms of the no of read accesses/program, the miss penalty in clock-cycles for a reading, and the reading miss-rate, is defined as

Q. Having a cache block of 4words, having one-word-wide bank of DRAMs and the miss penalty 65, then no of bytes transferred/bus-clock cycle for a single miss will be

Q. The range of designs between direct-mapped and fully-associative cache, is called

Q. The main memory of a computer can act as a

Q. If the entries no is a power of 2 in the cache, then modulo will be computed by using the

Q. Forget to accounting the byte addressing or the cache block-size, in processing a cache is a

Q. The principle of locality that was used; implementing memory of the computer as

Q. The program of copying address of PTE into temp $k1 would be executed with the instruction

Q. A field in the memory hierarchy table that indicates the associated block, is called a

Q. A virtual-memory block is known as page, and a virtual-memory miss is called a

Q. Latency clock rate of the AMD operation is,

Q. The decimal address having reference 22 will have a Binary address of reference

Q. Cache misses created by the 1st access to a block, that was not in the cache, is known as

Q. A situation in which the same object is being accessed by two addresses, is referred to as

Q. Hit-rate of the processor is the memory fraction, found in

Q. Kernel mode in which the operating system's programs run is also known as

Q. Total bits for a direct-mapped cache with data of 16 KB and blocks of 4-word, assuming a 32-bit address are

Q. The address location in the main memory, is referred to as