Q. If the 80386 enters the protected mode from the real address mode, then it returns back to the real mode, by performing the operation of

View solution

Q. The unit that is needed for virtual mode 80386, only to run the 8086 programs, which require more than 1 Mbyte of memory for memory management functions, is

View solution

Q. The number of pages that the paging unit allows, in the virtual mode of 80386 is

View solution

Q. The privilege level at which the real mode programs are executed is

View solution

Q. The instructions to prepare the processor for protected mode can only be executed at the privilege level

View solution

Q. The instruction that is unable to set or read the VM (Virtual Mode) bit is

View solution

Q. If the CKM pin of 80387 is high, then 80387 is operated in

View solution

Q. The unit that handles the data and directs it to either FIFO or instruction decoder depending on the bus control logic directive is

View solution

Q. The unit that is responsible for carrying out all the floating point calculations, allotted to the coprocessor by 80386, is

View solution

Q. The sizes of instruction and data pointer registers of 80387 respectively are

View solution

Q. To inform 80387 that the CPU wants to communicate with NPS1, the NPS1 line is directly connected to

View solution

Q. Which of the following is not a newly added instruction of 80386, that are not present in 80286?

View solution

Q. The BSF (bit scan forward) instruction scans the operand in the order

View solution

Q. The BSR (bit scan reverse) instruction scans the operand in the order

View solution

Q. If a ‘1’ is encountered when an operand is scanned by BSF, then

View solution

Q. If a ‘1’ is not encountered when an operand is scanned by BSR, then

View solution

Q. Which of the following is not a bit test instruction?

View solution

Q. In case of BT instruction, if the bit position in the destination operand specified by the source operand, is ‘1’, then

View solution

Q. Which of the following is not a conditional set byte instruction?

View solution

Q. The instruction that shifts the specified number of bits in the instruction, from the upper side of the source operand into the lower side of the destination operand is

View solution