Question
a.
zero flag is reset
b.
carry flag is set
c.
VM flag is set
d.
RF flag is reset
Posted under Microprocessor
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. In case of BT instruction, if the bit position in the destination operand specified by the source operand, is ‘1’, then
Similar Questions
Discover Related MCQs
Q. Which of the following is not a conditional set byte instruction?
View solution
Q. The instruction that shifts the specified number of bits in the instruction, from the upper side of the source operand into the lower side of the destination operand is
View solution
Q. The instruction that shifts 8 LSB bits of ECX into the MSB positions of EAX, one by one starting from LSB of ECX is
View solution
Q. The first processor with an inbuilt floating point unit is
View solution
Q. Which of the following signal is handled by bus control and request sequencer?
View solution
Q. The unit that subjects the processor operation to boundary scan tests is
View solution
Q. The management of the virtual memory of the system and adequate protection to data or codes in the physical memory is provided by
View solution
Q. The flag that is added to 80486 in additional to the flags similar to 80386 is
View solution
Q. The major limitation of 80386-387 system is
View solution
Q. The datatype that the 80486 does not support is
View solution
Q. In Little Endian data format, the data is stored as
View solution
Q. The on-chip cache is used for storing
View solution
Q. The on-chip cache is controlled by
View solution
Q. The on-chip cache can be flushed using external hardware using
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Microprocessor? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
