Q. The signal that is used to insert WAIT states in a bus cycle in 80386 is

View solution

Q. The signal which indicates to the CPU, to fetch a data word for the coprocessor is

View solution

Q. The pipeline and dynamic bus sizing units handle

View solution

Q. The 16-bit registers are available with their extended size of 32 bits, by adding the registers with a prefix of

View solution

Q. In a 32-bit register, ESP, the lower 16-bits of the register can be represented by

View solution

Q. Which of the following is a data segment register of 80386?

View solution

Q. The register width used by the 32-bit addressing modes is

View solution

Q. The flag that is additional in flag register of 80386, compared to that of 80286 is

View solution

Q. The VM (virtual mode) flag is to be set, only when 80386 is in

View solution

Q. In protected mode of 80386, the VM flag is set by using

View solution

Q. During the instruction cycle of 80386, any debug fault can be ignored if

View solution

Q. The RF is not automatically reset after the execution of

View solution

Q. The segment descriptor register is used to store

View solution

Q. The 32-bit control register, that is used to hold global machine status, independent of the executed task is

View solution

Q. The descriptor table that the 80386 supports is

View solution

Q. The registers that are together, known as system address registers are

View solution

Q. Which of the following is a system segment register?

View solution

Q. The test register(s) that is provided by 80386 for page caching is

View solution

Q. Among eight debug registers, DR0-DR7, the registers that are reserved by Intel are

View solution

Q. The registers that are used to store four program controllable break point addresses are

View solution