Q. Which of the following is not a data type of 80286?

View solution

Q. The representation of 8-bit or 16-bit signed binary operands using 2’s complement is a data type of

View solution

Q. The instruction that pushes the general purpose registers, pointer and index registers on to the stack is

View solution

Q. While executing the PUSH*A instruction, the stack pointer is decremented by

View solution

Q. The statement that is true for the instruction POP*A is

View solution

Q. The instruction that multiplies the content of AL with a signed immediate operand is

View solution

Q. The instruction that represents the ‘rotate source, count’ is

View solution

Q. In ‘Rotate source, count’ instructions, if the CF is equal to MSB of operand (source) then

View solution

Q. The instruction that affects the flags is

View solution

Q. A general protection exception is generated, if the value of

View solution

Q. While executing the instruction, OUTSW, the SI is incremented by

View solution

Q. The instruction that is used to exit the procedure is

View solution

Q. The instruction that determines the number of bytes, to be copied into the new stack frame, from the previous stack is

View solution

Q. The instruction that is used to check whether a signed array offset is within the limit, defined for it by the starting and ending index is

View solution

Q. The CLTS (Clear Task Switch Flag) instruction records every execution of WAIT and ESC and is trapped if the flag(s)

View solution

Q. The instruction that determines whether the segment pointed to, by a 16-bit register, can be accessed from the current privilege level is

View solution

Q. The instruction that loads 6 bytes from a memory block, pointed to by the effective address of the operand, into global descriptor table register is

View solution

Q. In LGDT instruction, while loading 6 bytes, the first word is loaded into the field of

View solution

Q. Which of the following is not a block of an architecture of 80287?

View solution

Q. The unit that provides and controls the interface, between the internal 80287 bus and 80286 bus via data buffer is

View solution