adplus-dvertising
frame-decoration

Question

While performing read operation, one must take care that much current should not be

a.

sourced from data lines

b.

sinked from data lines

c.

sourced or sinked from data lines

d.

sinked from address lines

Posted under Microprocessor

Answer: (c).sourced or sinked from data lines

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. While performing read operation, one must take care that much current should not be

Similar Questions

Discover Related MCQs

Q. To avoid loading during read operation, the device used is

Q. The chip 74LS245 is

Q. In 74LS245, if DIR is 1, then the direction is from

Q. In memory-mapped scheme, the devices are viewed as

Q. Programmable peripheral input-output port is another name for

Q. Port C of 8255 can function independently as

Q. All the functions of the ports of 8255 are achieved by programming the bits of an internal register called

Q. The data bus buffer is controlled by

Q. The input provided by the microprocessor to the read/write control logic is

Q. The device that receives or transmits data upon the execution of input or output instructions by the microprocessor is

Q. The port that is used for the generation of handshake lines in mode 1 or mode 2 is

Q. If A1=0, A0=1 then the input read cycle is performed from

Q. The function, ‘data bus tristated’ is performed when

Q. The pin that clears the control word register of 8255 when enabled is

Q. In the I/O mode, the 8255 ports work as

Q. In BSR mode, only port C can be used to

Q. The feature of mode 0 is

Q. The strobed input/output mode is another name of

Q. If the value of the pin STB (Strobe Input) falls to low level, then

Q. The signal, SLCT in the direction of signal flow, OUT, indicates the selection of