Q. The strobed input/output mode is another name of

View solution

Q. If the value of the pin STB (Strobe Input) falls to low level, then

View solution

Q. The signal, SLCT in the direction of signal flow, OUT, indicates the selection of

View solution

Q. The pulse width of the signal INIT at the receiving terminal must be more than

View solution

Q. The level of the signal ERROR(active low) becomes ‘low’ when the printer is in

View solution

Q. The signals that are provided to maintain proper data flow and synchronization between the data transmitter and receiver are

View solution

Q. The feature of mode 2 of 8255 is

View solution

Q. The time taken by the ADC from the active edge of SOC(start of conversion) pulse till the active edge of EOC(end of conversion) signal is called

View solution

Q. The popular technique that is used in the integration of ADC chips is

View solution

Q. The procedure of algorithm for interfacing ADC contain

View solution

Q. Which is the ADC among the following?

View solution

Q. The conversion delay in a successive approximation of an ADC 0808/0809 is

View solution

Q. The number of inputs that can be connected at a time to an ADC that is integrated with successive approximation is

View solution

Q. ADC 7109 integrated by Dual slope integration technique is used for

View solution

Q. Which of the following is not one of the phases of the total conversion cycle?

View solution

Q. Which of the following phase contain feedback loop in it?

View solution

Q. In the signal integrate phase, the differential input voltage between IN LO(input low) and IN HI(input high) pins is integrated by the internal integrator for a fixed period of

View solution

Q. DAC (Digital to Analog Converter) finds application in

View solution

Q. To save the DAC from negative transients the device connected between OUT1 and OUT2 of AD 7523 is

View solution

Q. An operational amplifier connected to the output of AD 7523 is used

View solution