Q. Microinstruction length is determined by ………………..

1) The maximum number of simultaneous micro-operations that must be specified
2) The way in which the control information is represented or encoded
3) The way in which the next microinstruction address is specified

View solution

Q. ID catching system, the memory reference made in any short time integral tends to use only a small fraction of the total memory?

View solution

Q. The word length of a CPU is defined as

View solution

Q. The register which holds the address of the locating to or from which data are to be transferred is known as

View solution

Q. Which one is required while establishing the communication link between CPU and peripherals?

View solution

Q. Which of the following data transfer modes takes relatively more time?

View solution

Q. Halt operation comes under ………

View solution

Q. The CPU initializes the DMA by sending ………

View solution

Q. In four – address instruction format, the number of bytes required to encode an instruction is (assume each address requires 24 bits, and 1 byte is required for operation code)

View solution

Q. The minimum time delay between the initiations of two independent memory operations is called

View solution

Q. Consider an algebraic system (A,*), where A is a set of all non-zero real numbers and * is a binary operation defined by A* b = ab/4 then (G*) is a

View solution

Q. A 2 level memory has an average access time of 30 ns with cache and memory access time as 20 ns and 150 ns respectively. What is the hit ratio?

View solution

Q. The following are some of the sequences of operations in the instruction cycle, which one is the correct sequence?

View solution

Q. Horizontal micro construction has which of the following attributes?
1) Short formats
2) Limited ability to express parallel micro-operations
3) Considerable encoding of the control information

View solution

Q. The register which keeps track of the execution of a program and which contains the memory address of the instruction currently being executed is known as …………

View solution

Q. Consider the following situation and fill in the blanks:

The computer starts the tape moving by issuing a command; the processor then monitors the status of the taps by means of a ………….. When the tape is in the correct position, the Processor issues a ……………

View solution

Q. For interval arithmetic best rounding technique use is ………..

View solution

Q. Assume that the time required for the eight functional units, which operate in each of the eight cycles, are as follows.

5us, 8us, 64s, 10us, 15us, 12us, 6us, 8us

Assume that pipe lining adds 1 us, of overhead. Find the speedup versus the single cycle data path.

View solution

Q. Assembler directives represent………………
1) Machine instructions to be included in the object program
2) The allocation of storage for constants or program variable

View solution

Q. The bus system of a machine has the following propagation delay times 40 ns for the signals to propagate through the multiplexers, 90ns to perform the ADD operating in the ALU, 30ns delay in the destination decoder, and 20ns to store the data into the destination register. What is the minimum cycle time that can be used for the clock?

View solution