Q. …………… improve system performance by temporarily storing data during transfers s/w devices or processers that operate at different speeds.

View solution

Q. Addressing mode is …………………

View solution

Q. Which of the following is not a valid class of interrupts?
1) Program
2) Timer
3) I/o
4) Hardware failure

View solution

Q. System calls are usually invoked by using

1) An indirect jump
2) A software interrupt
3) Polling
4) A privileged instruction

View solution

Q. Which of the following holds data and processing instructions temporarily until the CPU needs it??

View solution

Q. Which of the following register processors used for fetch and execute operations?
1) Program counter
2) Instruction register
3) Address register

View solution

Q. Microinstruction length is determined by ………………..

1) The maximum number of simultaneous micro-operations that must be specified
2) The way in which the control information is represented or encoded
3) The way in which the next microinstruction address is specified

View solution

Q. ID catching system, the memory reference made in any short time integral tends to use only a small fraction of the total memory?

View solution

Q. The word length of a CPU is defined as

View solution

Q. The register which holds the address of the locating to or from which data are to be transferred is known as

View solution

Q. Which one is required while establishing the communication link between CPU and peripherals?

View solution

Q. Which of the following data transfer modes takes relatively more time?

View solution

Q. Halt operation comes under ………

View solution

Q. The CPU initializes the DMA by sending ………

View solution

Q. In four – address instruction format, the number of bytes required to encode an instruction is (assume each address requires 24 bits, and 1 byte is required for operation code)

View solution

Q. The minimum time delay between the initiations of two independent memory operations is called

View solution

Q. Consider an algebraic system (A,*), where A is a set of all non-zero real numbers and * is a binary operation defined by A* b = ab/4 then (G*) is a

View solution

Q. A 2 level memory has an average access time of 30 ns with cache and memory access time as 20 ns and 150 ns respectively. What is the hit ratio?

View solution

Q. The following are some of the sequences of operations in the instruction cycle, which one is the correct sequence?

View solution

Q. Horizontal micro construction has which of the following attributes?
1) Short formats
2) Limited ability to express parallel micro-operations
3) Considerable encoding of the control information

View solution