Q. Why RETI instruction is used after an ISR?

View solution

Q. In AVR what is the ISR address for an external hardware interrupt?

View solution

Q. What is the address in the interrupt service routine assigned for the timer0 overflow flag?

View solution

Q. Is the same address is assigned for the timer0 and timer1 overflow flag in the interrupt vector table of the interrupts?

View solution

Q. External hardware interrupts are assigned to which pins of the atmega32?

View solution

Q. Which register is responsible for handling all the external hardware interrupts?

View solution

Q. By default, INT0-INT2 interrupts are?

View solution

Q. What will happen in that condition, if an interrupt occurs while the micro controller is serving any other interrupt?

View solution

Q. What actually are the DB9, DB25 ports available in our computers?

View solution

Q. What does RI handshaking signal refer to according to the RS232 logic?

View solution

Q. What is the major difference between a MAX232 and a MAX233 device?

View solution

Q. Which of the following is correct about the baud rate during serial transmission?

View solution

Q. With fosc= 8 MHz, what will the count that has to filled in the UBRR register to account for the 9600 baud rate?

View solution

Q. The USART in AVR based micro controllers operate at which of the following modes?

View solution

Q. Which bit of the UCSRA is used for doubling the baud rate of the transmission?

View solution

Q. What is the use of the PE and the FE bits of the UCSRA register?

View solution

Q. Which of the following bits are used for setting the data frame size?

View solution

Q. Which of the following parameters should the transmitter and the receiver agree upon before starting a serial transmission?

View solution

Q. In AVR, the LCD operates in two main modes, it can be in 8 bit or 4 bit data.

View solution

Q. What can be the sequence of commands that may be used for initializing an LCD?

View solution