Q. What can be the sequence of commands that may be used for initializing an LCD?

View solution

Q. When the LCD operates in the 4 bit mode, then what more commands are added to it?

View solution

Q. What is the main function of the LPM instruction used in LCD?

View solution

Q. The RS pin acts as an

View solution

Q. To latch in information at the data pins of the LCD, we send

View solution

Q. What is the function of the 0x06 command?

View solution

Q. What is the address of the second column and the second row of the 2*20 LCD?

View solution

Q. Which of the following commands takes more than 100 microseconds to run?

View solution

Q. For selecting the data pins in a LCD, RS pin should be

View solution

Q. In reading the columns of a keyboard matrix, when no key is pressed then all the pins show

View solution

Q. To see if any key is pressed, all rows are grounded.

View solution

Q. Identify the row and the column for the following case when for the row D3-D0= 1110 and for the column D3-D0= 1101

View solution

Q. What are the actual steps that are followed in identifying any key that is being pressed?

View solution

Q. To identify that the key is present in which row and the column

View solution

Q. The key detection and the key identification are two different procedures?

View solution

Q. What is described by the following command?
KCODE0<<1

View solution

Q. If the pins of the keyboard are used as an interrupt, then these pins will cause interrupt of what type?

View solution

Q. What will happen if two keys of the keyboard are pressed at a time?

View solution

Q. Why initially all keys are considered open before detecting the key pressed?

View solution

Q. Which of the following is correct about the word resolution in ADC DAC converters in AVR’s?

View solution