Q. The USART in AVR based micro controllers operate at which of the following modes?

View solution

Q. Which bit of the UCSRA is used for doubling the baud rate of the transmission?

View solution

Q. What is the use of the PE and the FE bits of the UCSRA register?

View solution

Q. Which of the following bits are used for setting the data frame size?

View solution

Q. Which of the following parameters should the transmitter and the receiver agree upon before starting a serial transmission?

View solution

Q. In AVR, the LCD operates in two main modes, it can be in 8 bit or 4 bit data.

View solution

Q. What can be the sequence of commands that may be used for initializing an LCD?

View solution

Q. When the LCD operates in the 4 bit mode, then what more commands are added to it?

View solution

Q. What is the main function of the LPM instruction used in LCD?

View solution

Q. The RS pin acts as an

View solution

Q. To latch in information at the data pins of the LCD, we send

View solution

Q. What is the function of the 0x06 command?

View solution

Q. What is the address of the second column and the second row of the 2*20 LCD?

View solution

Q. Which of the following commands takes more than 100 microseconds to run?

View solution

Q. For selecting the data pins in a LCD, RS pin should be

View solution

Q. In reading the columns of a keyboard matrix, when no key is pressed then all the pins show

View solution

Q. To see if any key is pressed, all rows are grounded.

View solution

Q. Identify the row and the column for the following case when for the row D3-D0= 1110 and for the column D3-D0= 1101

View solution

Q. What are the actual steps that are followed in identifying any key that is being pressed?

View solution

Q. To identify that the key is present in which row and the column

View solution