Q. The IOR (active low) input line acts as output in

View solution

Q. The IOW (active low) in its slave mode loads the contents of data bus to

View solution

Q. The pin that disables all the DMA channels by clearing the mode registers is

View solution

Q. The pin that requests the access of the system bus is

View solution

Q. The pin that is used to write data to the addressed memory location, during DMA write operation is

View solution

Q. The pin that strobes the higher byte of the memory address, generated by the DMA controller into the latches is

View solution

Q. The 8257 is able to accomplish the operation of

View solution

Q. The bus is available when the DMA controller receives the signal

View solution

Q. To indicate the I/O device that its request for the DMA transfer has been honoured by the CPU, the DMA controller pulls

View solution

Q. If more than one channel requests service simultaneously, the transfer will occur as

View solution

Q. The continuous transfer may be interrupted by an external device by pulling down the signal

View solution

Q. The number of clock cycles required for a 8257 to complete a transfer is

View solution

Q. In 8257, if each device connected to a channel is assigned to a fixed priority then it is said to be in

View solution

Q. The priority of the channels varies frequently in

View solution

Q. The register of 8257 that can only be written in is

View solution

Q. The operation that can be performed on the status register is

View solution

Q. In DMA the data transfer is controlled by

View solution

Q. Cycle stealing technique is used in

View solution

Q. During DMA acknowledgement cycle, CPU relinquishes

View solution

Q. Access time is faster for _________.

View solution