adplus-dvertising
frame-decoration

Question

In the transition phase, the term that refers to start of the communication is

a.

authenticate

b.

establish

c.

network

d.

terminate

Posted under Networking

Answer: (b).establish

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. In the transition phase, the term that refers to start of the communication is

Similar Questions

Discover Related MCQs

Q. Internet users use the

Q. The term that refers to a set of procedures used to restrict the amount of data that the sender can send before waiting for acknowledgment is

Q. The sequence numbers of the Stop-and-Wait Automatic Repeat Request are based on

Q. In the Password Authentication Protocol (PAP), the value of the protocol field is

Q. The Link Control Protocol packet that refers to accept the shut down request is used the code of

Q. In the Internet Protocol Control Protocol (IPCP), the code value of Ox04 is used to represent the packet of

Q. PPP is a

Q. Stop-and-Wait Automatic Repeat Request is a special case of

Q. In the control field, the first bit defines the

Q. Error control is the combination of

Q. The range of the possible sequence numbers of Go-Back-N Protocol which is the concern of the receiver is called the

Q. The Internet Protocol Control Protocol (IPCP) has a protocol field value of

Q. The protocol that deals with the Xerox protocol data packets are called

Q. The term that is used to define the end of the frame and the beginning of the next frame is called

Q. Each frame in HDLC may contain up to

Q. In multiple Point to Point Protocol, the value of the protocol field is

Q. In Normal Response Mode (NRM), the station configuration is

Q. The data section of the frame has an extra byte is called the

Q. In High-level Data Link Control (HDLC), the frame that is used only to transport control information is called

Q. Framing that is done on data link layer are of