adplus-dvertising
frame-decoration

Question

In the Internet Protocol Control Protocol (IPCP), the code value of Ox04 is used to represent the packet of

a.

Configure-request

b.

Configure-reject

c.

Terminate-request

d.

Code-reject

Posted under Networking

Answer: (b).Configure-reject

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. In the Internet Protocol Control Protocol (IPCP), the code value of Ox04 is used to represent the packet of

Similar Questions

Discover Related MCQs

Q. PPP is a

Q. Stop-and-Wait Automatic Repeat Request is a special case of

Q. In the control field, the first bit defines the

Q. Error control is the combination of

Q. The range of the possible sequence numbers of Go-Back-N Protocol which is the concern of the receiver is called the

Q. The Internet Protocol Control Protocol (IPCP) has a protocol field value of

Q. The protocol that deals with the Xerox protocol data packets are called

Q. The term that is used to define the end of the frame and the beginning of the next frame is called

Q. Each frame in HDLC may contain up to

Q. In multiple Point to Point Protocol, the value of the protocol field is

Q. In Normal Response Mode (NRM), the station configuration is

Q. The data section of the frame has an extra byte is called the

Q. In High-level Data Link Control (HDLC), the frame that is used only to transport control information is called

Q. Framing that is done on data link layer are of

Q. ATM wide-area network is an example of

Q. The protocol that is designed for use over dial-up links where verification of user is necessary is

Q. Error control in the data link layer is based on

Q. The Stop and Wait Protocol uses the link of

Q. Any time an error is detected then the specified frames are

Q. In a real-life network, the data link protocols are implemented as