Question
a.
regenerators
b.
ADMs
c.
STS multiplexer/demultiplexers
d.
none of the above
Posted under Networking
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. __________ allow insertion and extraction of signals.
Similar Questions
Discover Related MCQs
Q. A _______ is the optical link connecting two neighbor devices.
View solution
Q. A ______ is the portion of the network between two multiplexers.
View solution
Q. A ______is the end-to-end portion of the network between two STS multiplexers.
View solution
Q. The ______ layer is responsible for the movement of a signal from its optical source to its optical destination.
View solution
Q. The ____ layer is responsible for the movement of a signal across a physical line.
View solution
Q. The ______ layer is responsible for the movement of a signal across a physical section.
View solution
Q. The _______ layer corresponds to the physical layer of the OSI model.
View solution
Q. An STS multiplexer is a ______ device.
View solution
Q. An add/drop multiplexer is a ______ device.
View solution
Q. A regenerator is a ________ device.
View solution
Q. In SONET, for each frame, the bytes are transmitted __________.
View solution
Q. In SONET, for each byte, the bits are transmitted ____________.
View solution
Q. Each ________in a SONET frame can carry a digitized voice channel.
View solution
Q. Line overhead consists of ________ bytes.
View solution
Q. The path overhead consists of ______ bytes.
View solution
Q. In ________ APS, there are normally two lines: one working line and one protection line. Both lines are active all the time.
View solution
Q. In ______ APS, there is one working line and one protection line. The data are normally sent on the working line until it fails.
View solution
Q. In ________APS, there is only one protection line for many working lines. When a failure occurs in one of the working lines, the protection line takes control until the failed line is repaired.
View solution
Q. A control character is sent at the beginning as well as at the end of each block in the synchronous-transmission in order to
View solution
Q. Check sum is used for
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Networking? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!