Q. In Bluetooth, the L2CAP sublayer, is roughly equivalent to the LLC sublayer in LANs.

View solution

Q. The access method in Bluetooth is ________.

View solution

Q. In Bluetooth, the _____ link is used when avoiding latency (delay in data delivery) is more important than integrity (error-free delivery).

View solution

Q. In Bluetooth, the _____ link is used when data integrity is more important than avoiding latency.

View solution

Q. Bluetooth uses ______method in the physical layer to avoid interference from other devices or other networks.

View solution

Q. The frequency range of wireless LAN is

View solution

Q. _______ are wireless network standard with a data rate of only 2 Mbps .

View solution

Q. Cellular radio has another popular names as

View solution

Q. The disadvantages of mobile communication are

View solution

Q. ETSI stands for

View solution

Q. GSM (Global System for Mobile Communication) is a _______ digital mobile telephones standard using a combination Time Division Multiple Access (TDMA) and FDMA (Frequency Division Multiple Access).

View solution

Q. If either of the communicating device can ask for disconnection by sending DISCONNECT REQUEST TPDU to the other, and immediately disconnect without waiting for acknowledgement is called ...................

View solution

Q. As we go from long-wave radio towards visible light, the waves behave more and more like ................. and less and less like ..................

View solution

Q. Which IEEE 802 standard does not provide for a collision-free protocol?

View solution

Q. In switched 802.3 LANS, each card forms its own ................... independents of the others.

View solution

Q. 802.3 base band systems use ........................ encoding.

View solution

Q. In 802.3, each frame starts with a ................... of 7 bytes.

View solution

Q. In 802.3, the high order bit of the destination address is a ‘0’ for ................. addresses.

View solution

Q. In 802.3, the address consisting of all 1 bits is reserved for .................

View solution

Q. The .................... standard describes the upper part of the data link layer.

View solution