Q. The state of signals in power down mode is

View solution

Q. The signal that only pulls the microcontroller(8051) out of the power down mode is

View solution

Q. During power down to save battery, the supply voltage can be reduced to a value of

View solution

Q. The clock signal is disabled to all parts of 8051 in

View solution

Q. The microcontroller enters into power down mode when

View solution

Q. To come out of idle mode, the external interrupt that is enabled is

View solution

Q. The state of signals in idle mode is

View solution

Q. The power control register is

View solution

Q. The mode that offers the most secured parity enabled data communication at lower baud rates is

View solution

Q. In mode 2, the baud rate depends only on

View solution

Q. If the microcontroller is expected to communicate in a multiprocessor system, then the required condition is

View solution

Q. If SM0=1, SM1=0, then the transceiver selected is

View solution

Q. During serial reception, the buffer that receives serial bits and converts to a byte is

View solution

Q. The common unit shared by the receiver unit and transmission unit of serial communication unit is

View solution

Q. The transmission unit does not require assistance from processor if once a byte for transmission is written to

View solution

Q. The task of converting the byte into serial form and transmitting it bit by bit along with start, stop and parity bits is carried out by

View solution

Q. The number of bits transmitted or received per second is defined as

View solution

Q. The mcs 51 architecture supports

View solution

Q. The serial communication is used for

View solution

Q. The serial communication is

View solution