Q. How would you allow device drivers and TSR's to be loaded into Upper Memory Blocks ?

View solution

Q. Upper Memory blocks are located where?

View solution

Q. What component would most likely cause a "parity error"?

View solution

Q. Which of the following is a type of preventative maintenance used on a hard drive?

View solution

Q. A 2xx POST error code indicates a problem with:

View solution

Q. Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.

View solution

Q. Single Inline Memory Module (SIMM) holds

View solution

Q. The next-generation evolution of DDR memory is

View solution

Q. DDR requires ________ volts to operate.

View solution

Q. The speed of hard disk drive is measured in

View solution

Q. Pen drive is a

View solution

Q. ROM is a

View solution

Q. _________stores binary information using clocked sequential circuits.

View solution

Q. _________ stores binary information in the form of electric charges that are applied to capacitors inside the chip.

View solution

Q. The data recording density is measured in

View solution

Q. Storage capacity of a tape is equal to the product of data recording density and ________.

View solution

Q. Inter-track gaps are used to separate the adjacent tracks so that the interference of magnetic fields is ________.

View solution

Q. Tracks are commonly divided into sections called _________.

View solution

Q. If there are 100 tracks on each disk surface, there are ________ cylinders in the disk pack.

View solution

Q. If a disk pack consists of 4 plates each having 2655 tracks having 125 sectors per track. Also, each sector can store 512 bytes, then, storage capacity is approximately.

View solution