adplus-dvertising
frame-decoration

Question

How would you allow device drivers and TSR's to be loaded into Upper Memory Blocks ?

a.

DOS=High

b.

devicehigh=

c.

loadhigh=

d.

DOS=UMB

Posted under Computer Hardware

Answer: (d).DOS=UMB

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. How would you allow device drivers and TSR's to be loaded into Upper Memory Blocks ?

Similar Questions

Discover Related MCQs

Q. Upper Memory blocks are located where?

Q. What component would most likely cause a "parity error"?

Q. Which of the following is a type of preventative maintenance used on a hard drive?

Q. A 2xx POST error code indicates a problem with:

Q. Your IDE hard drive is not spinning up when you turn on the PC. What is the most likely problem.

Q. Single Inline Memory Module (SIMM) holds

Q. The next-generation evolution of DDR memory is

Q. DDR requires ________ volts to operate.

Q. The speed of hard disk drive is measured in

Q. Pen drive is a

Q. ROM is a

Q. _________stores binary information using clocked sequential circuits.

Q. _________ stores binary information in the form of electric charges that are applied to capacitors inside the chip.

Q. The data recording density is measured in

Q. Storage capacity of a tape is equal to the product of data recording density and ________.

Q. Inter-track gaps are used to separate the adjacent tracks so that the interference of magnetic fields is ________.

Q. Tracks are commonly divided into sections called _________.

Q. If there are 100 tracks on each disk surface, there are ________ cylinders in the disk pack.

Q. If a disk pack consists of 4 plates each having 2655 tracks having 125 sectors per track. Also, each sector can store 512 bytes, then, storage capacity is approximately.

Q. The average seek time in most systems is