Q. In ________ protocols, we use ________.

View solution

Q. Bit stuffing means adding an extra 0 to the data section of the frame when there is a sequence of bits with the same pattern as the ________.

View solution

Q. ______ control refers to methods of error detection and correction.

View solution

Q. The Simplest Protocol and the Stop-and-Wait Protocol are for ______ channels.

View solution

Q. The ____ Protocol has neither flow nor error control.

View solution

Q. The _______Protocol has flow control, but not error control.

View solution

Q. The _______Protocol has both flow control and error control.

View solution

Q. In the _____ Protocol, the sender sends its frames one after another with no regard to the receiver.

View solution

Q. In the _____ Protocol, the sender sends one frame, stops until it receives confirmation from the receiver, and then sends the next frame.

View solution

Q. The _________Protocol, adds a simple error control mechanism to the _______Protocol.

View solution

Q. In the _________Protocol, if no acknowledgment for a frame has arrived, we resend all outstanding frames.

View solution

Q. In the _________ protocol we avoid unnecessary transmission by sending only frames that are corrupted.

View solution

Q. Both Go-Back-N and Selective-Repeat Protocols use a _________.

View solution

Q. In Go-Back-N ARQ, if 5 is the number of bits for the sequence number, then the maximum size of the send window must be _____.

View solution

Q. In Go-Back-N ARQ, if 5 is the number of bits for the sequence number, then the maximum size of the receive window must be _____.

View solution

Q. In Selective Repeat ARQ, if 5 is the number of bits for the sequence number, then the maximum size of the send window must be _____.

View solution

Q. In Selective Repeat ARQ, if 5 is the number of bits for the sequence number, then the maximum size of the receive window must be _____.

View solution

Q. High-level Data Link Control (HDLC) is a _______ protocol for communication over point-to-point and multipoint links.

View solution

Q. The most common protocol for point-to-point access is the Point-to-Point Protocol (PPP), which is a _________protocol.

View solution

Q. _______ control refers to a set of procedures used to restrict the amount of data that the sender can send before waiting for acknowledgment.

View solution