Q. Baud rate is the reverse of the

View solution

Q. The _____ rate gives the frequency at which the bits are transmitted on the line.

View solution

Q. In asynchronous mode of transmission, usually the data is sent along with the

View solution

Q. Asynchronous serial communication usually requires two wires for each direction plus a common ground.

View solution

Q. UCB0RXIFG is set when

View solution

Q. How is I2C with USI different from I2C with USI_B?

View solution

Q. Is baud rate selected in I2C?

View solution

Q. Which of the following is the slave to be addressed when a device acts as a master

View solution

Q. Which of the following is an issue while programming I2C using software?

View solution

Q. Rising edge on SDA while SCL is high denotes

View solution

Q. Pull-up resistors Rp keep the lines at VCC when

View solution

Q. Each slave has its unique address.

View solution

Q. I2C is faster means of data transfer than SPI?

View solution

Q. The I2C bus uses which of the following lines

View solution

Q. Falling edge of the SS pin denotes

View solution

Q. When the buffer is________ the low power mode is__________

View solution

Q. Transmission and reception are made at a time in SPI?

View solution

Q. SCLK, SDO, and SDI are found___________on F20x3.

View solution

Q. SPI with the USI can be selected by

View solution

Q. Is CPKH and CPOL the same

View solution