Question
a.
the start bit
b.
the stop bit
c.
both of the mentioned
d.
none of the mentioned
Posted under Computer Architecture
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. In asynchronous mode of transmission, usually the data is sent along with the
Similar Questions
Discover Related MCQs
Q. Asynchronous serial communication usually requires two wires for each direction plus a common ground.
View solution
Q. UCB0RXIFG is set when
View solution
Q. How is I2C with USI different from I2C with USI_B?
View solution
Q. Is baud rate selected in I2C?
View solution
Q. Which of the following is the slave to be addressed when a device acts as a master
View solution
Q. Which of the following is an issue while programming I2C using software?
View solution
Q. Rising edge on SDA while SCL is high denotes
View solution
Q. Pull-up resistors Rp keep the lines at VCC when
View solution
Q. Each slave has its unique address.
View solution
Q. I2C is faster means of data transfer than SPI?
View solution
Q. The I2C bus uses which of the following lines
View solution
Q. Falling edge of the SS pin denotes
View solution
Q. When the buffer is________ the low power mode is__________
View solution
Q. Transmission and reception are made at a time in SPI?
View solution
Q. SCLK, SDO, and SDI are found___________on F20x3.
View solution
Q. SPI with the USI can be selected by
View solution
Q. Is CPKH and CPOL the same
View solution
Q. When CPOL=1 then,
View solution
Q. Writing on the trailing edge of the clock pulse and reading on the leading edge of the clock pulse is done when
View solution
Q. The concept of SPI is based on
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Computer Architecture? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
