Question
a.
the pointer to jump if the values of the destination and the source address are equal
b.
sets CY=1, if the contents of destination register is greater then that of the source register
c.
sets CY=0, if the contents of destination register is smaller then that of the source register
d.
none of the mentioned
Posted under Computer Architecture
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. CJNE instruction makes
Similar Questions
Discover Related MCQs
Q. XRL, ORL, ANL commands have
View solution
Q. What is the clock source for the timers?
View solution
Q. What is the frequency of the clock that is being used as the clock source for the timer?
View solution
Q. What is the function of the TMOD register?
View solution
Q. What is the maximum delay that can be generated with the crystal frequency of 22MHz?
View solution
Q. Auto reload mode is allowed in which mode of the timer?
View solution
Q. Find out the roll over value for the timer in Mode 0, Mode 1 and Mode 2?
View solution
Q. What steps are followed when we need to turn on any timer?
View solution
Q. If Timer 0 is to be used as a counter, then at what particular pin clock pulse need to be applied?
View solution
Q. In the instruction “MOV TH1,#-3”, what is the value that is being loaded in the TH1 register ?
View solution
Q. TF1, TR1, TF0, TR0 bits are of which register?
View solution
Q. Which devices are specifically being used for converting serial to parallel and from parallel to serial respectively?
View solution
Q. What is the difference between UART and USART communication?
View solution
Q. Which of the following best describes the use of framing in asynchronous means of communication?
View solution
Q. Which of the following signal control the flow of data?
View solution
Q. Which of the following is the logic level understood by the micro-controller/micro-processor?
View solution
Q. What is null modem connection?
View solution
Q. Which of the following best states the reason that why baud rate is mentioned in serial communication?
View solution
Q. With what frequency UART operates( where f denoted the crystal frequency )?
View solution
Q. What is the function of SCON register?
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Computer Architecture? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
