Q. Does the two instructions mean the same?
1) BACK: DEC R0

JZ BACK

2) BACK: DJNZ RO, BACK

View solution

Q. To initialise any port as an output port what value is to be given to it?

View solution

Q. Which out of the four ports of 8051 needs a pull-up resistor for using it is as an input or an output port?

View solution

Q. Which of the ports act as the 16 bit address lines for transferring data through it?

View solution

Q. Which of the following registers are not bit addressable?

View solution

Q. Which instruction is used to check the status of a single bit?

View solution

Q. Which addressing mode is used in pushing or popping any element on or from the stack?

View solution

Q. Which operator is the most important while assigning any instruction as register indirect instruction?

View solution

Q. What is the advantage of register indirect addressing mode?

View solution

Q. Which of the following comes under indexed addressing mode?

View solution

Q. Is this a valid statement ?
SETB A

View solution

Q. When we add two numbers the destination address must always be.

View solution

Q. DAA command adds 6 to the nibble if:

View solution

Q. If SUBB A,R4 is executed, then actually what operation is being applied?

View solution

Q. A valid division instruction always makes:

View solution

Q. In 8 bit signed number operations, OV flag is set to 1 if:

View solution

Q. In unsigned number addition, status of which bit is important?

View solution

Q. Which instructions have no affect on the flags of PSW?

View solution

Q. ANL instruction is used

View solution

Q. CJNE instruction makes

View solution