Q. The speed of conversion is maximum in

View solution

Q. The gates required to build a half adder are

View solution

Q. If the input to T-flipflop is 100 Hz signal, the final output of the three T-flipflops in cascade is

View solution

Q. The device which changes from serial data to parallel data is

View solution

Q. A device which converts BCD to Seven Segment is called

View solution

Q. The access time of ROM using bipolar transistors is about

View solution

Q. The A/D converter whose conversion time is independent of the number of bits is

View solution

Q. A 4-bit synchronous counter uses flip-flops with propagation delay times of 15 ns each. The maximum possible time required for change of state will be

View solution

Q. Words having 8-bits are to be stored into computer memory. The number of lines required for writing into memory are

View solution

Q. In successive-approximation A/D converter, offset voltage equal to 1/2 LSB is added to the D/A converter’s output. This is done to

View solution

Q. How many flip flops are required to construct a decade counter

View solution

Q. Which TTL logic gate is used for wired ANDing

View solution

Q. The MSI chip 7474 is

View solution

Q. When the set of input data to an even parity generator is 0111, the output will be

View solution

Q. How many flip-flops are required to construct mod 30 counter

View solution

Q. The number of control lines for 16 to 1 multiplexer is

View solution

Q. The number of control lines for 32 to 1 multiplexer is

View solution

Q. The logic 0 level of a CMOS logic device is approximately

View solution

Q. How many select lines will a 32:1 multiplexer will have

View solution

Q. Which of following consume minimum power?

View solution