Question
a.
incremented by 1
b.
decremented by 1
c.
incremented by 2
d.
decremented by 2
Posted under Microprocessor
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. In POP instruction, after each execution of the instruction, the stack pointer is
Similar Questions
Discover Related MCQs
Q. The instructions that are used for reading an input port and writing an output port respectively are
View solution
Q. The instruction that is used for finding out the codes in case of code conversion problems is
View solution
Q. The instruction that loads effective address formed by destination operand into the specified source register is
View solution
Q. The instruction that loads the AH register with the lower byte of the flag register is
View solution
Q. The instruction that pushes the flag register on to the stack is
View solution
Q. The instruction that loads the flag register completely from the word contents of the memory location is
View solution
Q. The instruction that adds immediate data/contents of memory location specified in an instruction/register to the contents of another register/memory location is
View solution
Q. The instruction that supports addition when carry exists is
View solution
Q. The instruction, “INC” increases the contents of the specified register or memory location by
View solution
Q. The instruction that subtracts 1 from the contents of the specified register/memory location is
View solution
Q. The instruction that enables subtraction with borrow is
View solution
Q. The flag that acts as Borrow flag in the instruction, SBB is
View solution
Q. In general, the source operand of an instruction can be
View solution
Q. In general, the destination operand of an instructon can be
View solution
Q. The instruction, CMP to compare source and destination operands it performs
View solution
Q. During comparison operation, the result of comparing or subtraction is stored in
View solution
Q. The instruction that converts the result in an unpacked decimal digits is
View solution
Q. If MN/MX is low the 8086 operates in __________ mode.
View solution
Q. A _____ Instruction at the end of interrupt service program takes the execution back to the interrupted
program.
View solution
Q. Which family was the sixth member of 8086 family of microprocessors?
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Microprocessor? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
.png)
