adplus-dvertising
frame-decoration

Question

The address and data information is typically referred to as the

a.

Request payload

b.

Link

c.

Tailer

d.

Message payload

Posted under Network Layer Networking

Answer: (d).Message payload

Engage with the Community - Add Your Comment

Confused About the Answer? Ask for Details Here.

Know the Explanation? Add it Here.

Q. The address and data information is typically referred to as the

Similar Questions

Discover Related MCQs

Q. The routing algorithm can allow packets to use resources in increasing partial order, first traversing up the tree until they reach some

Q. Paths that have an unbounded number of allowed nonminimal hops from packet sources, this situation is referred to as

Q. The type of network that is used for interprocessor and processor-memory interconnections within multiprocessor, are

Q. The entire routing path is precomputed by the source, possibly by table lookup, placed in the packet header for

Q. The term of a transmission medium that refers to the range of frequencies for which the attenuation per unit length is

Q. A long linear pipeline without staging in which signals propagate as waves through the network transmission medium, the function is refered as

Q. The effective bandwidth delivered end-to-end by the network to an application is upper bounded by the minimum across all three potential bottleneck areas:

Q. Aggregate bandwidth refers to the total data bandwidth supplied by the network, and

Q. In a switch pipeline, a single packet header indicates how to process all of the internal data path physical transfer units also known as

Q. Some network interfaces include extra hardware to offload protocol processing from the host computer, such as

Q. Packets that lose arbitration have to be buffered, which increases packet latency by some

Q. Schemes that reduce traffic when the collective traffic of all nodes is too large for the network to handle, refers to

Q. Many network interface cards implement hardware timers as well as hardware support to split messages into packets and reassemble them, compute the

Q. When the number of switch ports is equal to or larger than the number of devices, this simple network is refered to as

Q. Distributing the network switches among the end nodes, which then become

Q. To pipeline packet transmission across the circuit using staging at each hop along the path, a technique known as

Q. No blocking occurs as links are not shared among paths to unique destinations, the crossbar, therefore, is

Q. No more than three nodes in a commercial systems are known as

Q. When requested network paths are available for packets, it is known as

Q. The sum of time of flight and transmission time, is called a