Question
a.
LLC Sub layer
b.
MAC Sub layer
c.
LLC Control Layer
d.
MAC Control Layer
Posted under Ethernet Networking
Engage with the Community - Add Your Comment
Confused About the Answer? Ask for Details Here.
Know the Explanation? Add it Here.
Q. The terms that control the flow and errors in full duplex switched Ethernet is called
Similar Questions
Discover Related MCQs
Q. In 10Base2, the cable is
View solution
Q. Preamble contains
View solution
Q. The maximum length of optical fiber in 10BaseF is
View solution
Q. A destination address can be
View solution
Q. In Ethernet frame, both destination and sender addresses are of length
View solution
Q. In 100BaseT4 the total number of wires are
View solution
Q. The original Ethernet was created in
View solution
Q. The Ethernet frame contains
View solution
Q. The Computer Society of the IEEE started a project named project 802 in
View solution
Q. NIC stand for
View solution
Q. A source address is always a
View solution
Q. In gigabit Ethernet three or more stations are connected by
View solution
Q. The term that is used to set standards to enable intercommunication among equipment from a variety of manufacturers is called
View solution
Q. In 10Base5, the maximum length of the coaxial cable is
View solution
Q. IEEE Standard was adopted by the
View solution
Q. Media access control is the sub layer of
View solution
Q. The minimum frame length for 1O-Mbps Ethernet is 64 bytes and the maximum is
View solution
Q. In half duplex mode of MAC sublayer the stations are connected via
View solution
Q. Fast Ethernet can transmit data at the rate of
View solution
Q. In the full duplex mode of gigabit Ethernet, there is no
View solution
Suggested Topics
Are you eager to expand your knowledge beyond Networking? We've curated a selection of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of Computer Science. Happy exploring!
